Gm160 Programming Software: Motorola
The CPS interface might look complex, but it is logically organized.
button. The radio will typically beep or show a "Programming" message on the display. Once finished, the radio will restart with your new settings active. Troubleshooting Common Issues "Communication Error":
Set up MDC1200, Quick-Call II, and DTMF signaling for selective calling, radio check, and emergency alerts. motorola gm160 programming software
The specific software required for the GM160 is listed in Motorola’s internal documentation as version R06.12.05 or R06.12.07 . Some users also report success with RVN4174 or RVN4175 (the part numbers for the programming kits).
: Motorola Commercial Series CPS (sometimes referred to as Professional Radio CPS). Region-Specific Versions The CPS interface might look complex, but it
Before attempting to program your GM160, you must assemble the correct hardware interface and ensure your computer environment is compatible with legacy software. Required Hardware:
The Motorola GM160 is programmed using a version of the , such as versions R06.07.04 or R06.11.07_rus . The exact version you need depends on your radio's firmware. Once finished, the radio will restart with your
You need a cable that fits the GM160’s rear port. The official part number is (which connects from RIB to radio). However, if you buy a "RIB-less" cable, it will have a DB9 serial connector on one end and the 16-pin Motorola plug on the other.
