Xycd60 Manual Page

Short-press to cycle through parameters: UP (Upper limit), dn (Lower limit), OP (Conduction time), dOP (Delay start time). Use UP/DOWN buttons to adjust values. Long-press SET (approx. 5s) to save. 2. Key Specifications Voltage Range : 6V to 60V DC. Control Precision : 0.1V.

6V - 60V (Handles 12V, 24V, 36V, 48V systems) Max Current: Up to 10A (Continuous) Modes: Charging (IN) / Discharging (OUT) Display: 3-digit Segment Display Protection: Reverse Polarity Protection 2. Interface and Button Functions The module has four main buttons for navigation:

) and opens (cuts off load) when the voltage falls to the lower limit ( 3. Setting Parameters To configure the module, use the following button sequence: Enter Setting Mode: Long press the Switch Parameters: Short press to cycle through parameters: (upper limit), (lower limit), and (time control). Adjust Values: buttons to increase or decrease values. Save and Exit: Long press for 5 seconds to save and return to the main interface. Switch Modes: Long press the button for 5 seconds to toggle between Charging ( ) and Discharging ( 4. Advanced Functions

This operational guide details the specific technical specifications, wiring configurations, programming variables, and step-by-step procedures to customize your XY-CD60 module on ICStation or similar online platforms. Technical Specifications Summary xycd60 manual

As I looked down at my hands, I realized they were no longer human. I was one of them now, a being capable of transcending the boundaries of species, of time, and of space. The manual, it seemed, was not a guide but a catalyst.

| Battery Type / Voltage | Upper Limit (UP, overcharge) | Lower Limit (dn, cut‑off) | | :--------------------- | :--------------------------- | :------------------------- | | 12V Lead‑Acid (AGM/GEL) | 14.4 V – 14.7 V | 10.5 V – 11.0 V | | 12V LiFePO₄ | 14.4 V – 14.6 V | 10.0 V – 11.0 V | | 24V Lead‑Acid | 28.8 V – 29.4 V | 21.0 V – 22.0 V | | 48V Lead‑Acid | 57.6 V – 58.8 V | 42.0 V – 44.0 V |

Deep within the dusty recesses of the old antique shop, nestled between a vintage typewriter and a stack of yellowed letters, lay a peculiar booklet. Its cover, made of a material that felt both rubbery and metallic to the touch, bore the inscription "Xycd60 Manual" in letters that seemed to shift and shimmer in the dim light of the shop. The air around it seemed to vibrate with an otherworldly energy, as if the very pages held secrets that were not meant for mortal eyes. Short-press to cycle through parameters: UP (Upper limit),

Prevents overcharging. The relay closes to start charging when battery voltage falls below the lower limit ( dn ) and opens when it hits the upper limit ( UP ).

Long‑press the DOWN button. Set L‑P to ON (auto‑off after 5–10 minutes) or OFF (backlight always on).

The XY-CD60 is a versatile and intelligent battery charge and discharge controller module, widely used to protect and automate the charging cycles for various battery types. In simple terms, it acts as a smart automatic switch, using its built-in relay and user-set voltage limits to connect or disconnect your charger and load. 5s) to save

XY-CD60 / XY-CD63L Manual: Comprehensive Guide & Setup Instructions

Prevents overcharging. When the battery voltage drops to a user-set lower limit ( dn ), the relay closes to begin charging. Once it hits the upper limit ( UP ), the relay opens to stop.

Connect to the battery terminals to be monitored.