Moeller — Easy512-ac-rc Programming Manual

Contains exactly 1 output coil (Outputs, Timers, Counters) located on the far right. Common Operands and Symbols I1 – I8: Physical hardware inputs. Q1 – Q4: Physical hardware relay outputs.

Place contact I1 in Column 1, Rung 1. Move to Column 4 and select coil Q1 . Move down to Rung 2, Column 1. Place contact I2 .

(Implement in EASY Soft using its contact/coil elements; adapt addresses per module.) moeller easy512-ac-rc programming manual

The cornerstone of programming the easy512-ac-rc is the official user manual. This document guides users through the entire process from installation and commissioning to detailed programming of circuit diagrams.

Use the Up/Down keys to change the number (e.g., changing I1 to I2 ). Contains exactly 1 output coil (Outputs, Timers, Counters)

A dedicated circuit line must be assigned to reset the counter value back to zero. 6. Alternative Programming via easySoft Software

Remove the plastic interface cover on the front face of the Easy512. Insert the cable connector into the device interface slot. Place contact I1 in Column 1, Rung 1

Forcing outputs while wired to actuators can be dangerous. Disconnect loads first.