V2000-c Rfid Access Control User Manual

: Press * followed by your Master Code (Factory Default is usually 999999 or 123456 ), then press # .

A common frustration with new access control installs is the "door didn't open" issue. Usually, this isn't a broken lock, but a timing issue.

[Card + PIN mode: User must both present a registered card AND enter a 6-digit PIN] V2000-c Rfid Access Control User Manual

: Press * to exit and return to normal operation.

Use the provided security screwdriver to remove the back housing from the keypad. : Press * followed by your Master Code

Indicator : The LED indicator will turn red or flash slowly, indicating successful entry.

Choose a highly visible location adjacent to the entry door, ideally . [Card + PIN mode: User must both present

If you forget the Master Code or wish to completely wipe the device settings, follow these steps: Turn off the power to the unit. Press and hold the # key while turning the power back on. Release the # key after hearing two short beeps.

All programming is done via keypad after entering + # .