Gp Ethernet Printer Tool V5.0 !!top!!

Open Windows > Network and Sharing Center > Change adapter settings . Right-click your Ethernet connection and select Properties . Double-click Internet Protocol Version 4 (TCP/IPv4) . Select Use the following IP address and enter:

Mastering Your Gprinter Setup: A Guide to GP Ethernet Printer Tool V5.0 gp ethernet printer tool v5.0

If you change the IP but the printer reverts to the old one after a restart, ensure you are clicking the "Save" or "Send" button inside the tool. Simply typing the numbers is not enough—you must send the command to the printer memory. Open Windows > Network and Sharing Center >

The printer will print a self-test page listing its current , Subnet Mask , and Gateway . Step 2: Match Your PC's Network Segment Select Use the following IP address and enter:

: Reboot the printer and run a self-test page to confirm the new network address is active. Supported Devices

: Security software or windows firewall blocks the raw sockets used by the GP utility.

Check your self-test slip by holding the FEED button while powering on the printer. Note the IP printed. Change your computer's IP address manually to match the first three sets of numbers on that slip, then search again. IP Modification Fails Cause: Security software blocking raw network sockets.