Step 2: Force the Controller into Test Mode (Hardware Short)
For FA00 controllers, Full Scan4 (AutoECC) is often the most reliable for bypassing firmware "Unknown" errors. 4. Execute the Flash alcor micro unknown fa00 f w fa04 work
in the configuration, though this will halve the reported capacity. Hardware Test Mode (Last Resort) Step 2: Force the Controller into Test Mode
(If your ChipGenius diagnostic readout displayed custom numbers like 058F and 1234 , input those exact values instead). Save and close the file. Phase 4: Configure AlcorMP for Firmware Flashing Hardware Test Mode (Last Resort) (If your ChipGenius
This error indicates that the controller chip is alive, but its communication loop with the NAND flash memory is broken. The firmware (F/W) has either corrupted or is unable to read the Flash ID (FID).
Open , go to the ECC configuration block, and increase the ECC threshold to 12 or 15 to compensate for degraded sectors. Drive Capacity Halved After Flash
AlcorMP Main Dashboard ┌────────────────────────────────────────────────────────┐ │ [G:] Port 1: [FA00] Ready to Flash │ ├────────────────────────────────────────────────────────┤ │ Scan Mode: [Low Level Format] │ │ Optimization: [Capacity Optimize] │ │ ECC Level: [AutoECC] │ ├────────────────────────────────────────────────────────┤ │ [ Start (A) ] [ Setup (S) ] [ Refresh ] │ └────────────────────────────────────────────────────────┘ Phase 5: Execute the Flash Process